battleaxe 0 Report post Posted June 23, 2018 Just swapped PS pumps. put my oem pulley back on. the whole assembly has in and out play. the pulley itself seems to have some play in it as well. the bolt is tightened by having the nut tightened with a extension holding the pulley through the access hole. is my oem pulley splines just worn? is it normal to have in and out play on that shaft? Share this post Link to post Share on other sites
Lofty 0 Report post Posted June 25, 2018 I can try to check mine when I get back to the shop. I don't think so though. Share this post Link to post Share on other sites
AcidTrip 0 Report post Posted October 30, 2018 mine has a little wobble aswell even when torque to proper spec or higher. every pump ive had does the same shit and ive gone through alot of ps pumps. Share this post Link to post Share on other sites
brian 0 Report post Posted October 30, 2018 is this the hydro fan water pump? Share this post Link to post Share on other sites
battleaxe 0 Report post Posted December 17, 2018 Didn't notice this, but no, not hydro. Also, I flipped my aluminum pulley I had around and it aligned correctly as the IS pump sticks out a few mm more than the 1jz's Share this post Link to post Share on other sites