Jump to content
Sign in to follow this  
brian

IS300 R154 rear insulator

Recommended Posts

What is everyone using for the rear rubber insulator for a JZX90-110 R154 in a IS300? I know you have to use the automatic crossmember, but everything I am reading is saying the JZX100 mount lets the trans bolt in like factory but was hoping there was a US equivalent to this insulator.

Share this post


Link to post
Share on other sites

Paging Austin haha.

 

I wonder if you could run an x7/x8 crossmember since they have the dip to allow the insulator to be mounted lower. The width would have to be the same (no idea if it is)

I bet this is something XM wouldn't mind producing (as they could help them sell their poly trans mounts too)

 

Looks like this dude did all the measuring already
http://my.is/forums/f114/finally-found-shop-make-my-r154-tranny-bracket-is300-9-8-15-a-444254/index3.html

Share this post


Link to post
Share on other sites

Please sign in to comment

You will be able to leave a comment after signing in



Sign In Now
Sign in to follow this  

×