Jump to content
Sign in to follow this  
Ausdogga

1jz ecu wiring. jzx81 loom into a mx83 series 2 grande

Recommended Posts

hey guys new to the forum, over the last week or so I have been doing the 1jz conversion into the almighty mx83 it has been pretty cruisy

until now. forgive me for being a dumb fuck but I cant do wiring so well. I have a jzx81 loom that came out of a running mx83 but was a glx,

there a re a few plugs I cant figure out. can you guys give me a hand please and thanks. <3 ill upload a few pics in a sec as they are on my phone.

Share this post


Link to post
Share on other sites

The fuck is this shit. Series 1? Series 2? Who gives a fuck. Is that image supposed to appear right side up in Australia? Get the manuals. Get the pin outs. Put two and two together.

Share this post


Link to post
Share on other sites

You can't expect him to do that Urrik. after all he wasn't smart enough to read the forum rules.

Fucking retard............

Share this post


Link to post
Share on other sites

Your mommy must tell you that you are special,

every morning before you climb onto the short bus,

that takes you to the special school,

where they tell you that you are special.

When in fact, you are just another fucking retarded kid, because you crack whore mother did way too many drugs after you were accidentally concieved.

Did she actually remember who your father was ?

 

shortbus.jpg

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
Sign in to follow this  

×