-
Content Count
48 -
Joined
-
Last visited
Community Reputation
0 NeutralAbout warped83
-
Rank
I♥5M
- Birthday 01/27/1979
Previous Fields
-
Country
New Zealand
Profile Information
-
Gender
Male
-
Location
Auckland, NewZealand
-
Powered By
7MGE
-
Did you reconnect the plug from the light stalk to the loom?
-
New memeber Intro ok i follow rulebook cool!
warped83 replied to caliscrapen666's topic in Cressida Mark II Chaser Cresta Verossa IS Altezza
Stop replying, faggot! -
Check email mark.
-
Take it to the guy/ shop that built it. Do what Gordo said.
-
You dont need to weld in holes. Theyre already there except for the panhard rod mount which needs to be cut on the left rear. Hilux diff that shit, more worthwhile. Whats the point of adding so much weight for a three bolt mounted diff which gives you less options. Srick to the love axle.
-
Op a kiwi?
-
Reprocussions - Giggity!
-
They're different for the control valve assy. Rack and pinion are same between the two ( pre 2000 models.).XE10- 04445-53010 X100- 04445-22240
-
fuck that, will do it when i remove the subframe and go through your post of bracing the damn thing.
-
Not interested in the drift fanboifaggotry as kyle puts it. Just after something more refined albeit affordable than the current piece of shit i have at the back. Thanks Gordo, the chattering doesn't bother me and its not excessive just wanted to be sure i didn't fuck up the carrier preload while assembling.
-
Hey Gordo, was wondering if you could shed some light on this. I have a MA70 (G305) center swapped into a G312 cressida diff. I recently replaced my diff oil to the redline shockproof blue stuff. Recently the cars started snapping/Jerking on tight corners and even does it on take off be it soft medium or balls to the wall. Backlash or just the LSD center?. I've not been able to get the car on a hoist due to busy work. any insight as always is appreciated.
-
Aren't the TrueTrac and Detroit Locker one in the same kyle? Thanks Gordo, I'm currently running the G305 rear center also ramped up AND with increased pre load but its just crude. Any other aspects besides the machining of the side gears? Off set for the crown etc because like you and the seller i purchased the diff from mentioned its for a Toyota 8 inch rear but includes the G series from 86 to 95. Thanks again
-
As per title. Part Number 913A610. Any experience and or advice.
-
Noice, same color as mine too.
-
Haha..Your car sounds nasty. Good stuff!